ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Anyone familiar with Cooper Industries LCR8A DMX lights?  (Read 1760 times)

Mike McGuire

  • Newbie
  • *
  • Offline Offline
  • Posts: 5
Anyone familiar with Cooper Industries LCR8A DMX lights?
« on: April 17, 2014, 08:17:08 pm »

We have an installation where Cooper Industries LCR8A DMX lights were used for house lighting and wired up by the electricians.  Our trouble is getting DMX to talk to these lights and wondering if anyone on these boards has experience with them?  We also can't seem to figure out the address of these lights since there is no way to set them.  They are physically hardwired lights, driver to driver, and the home runs land at our DMX controller.  Our DMX controller is a Jands Vista M1.

So far we've attempted to verify that wiring is correct and we suspect the default address is around the 101-108 value since 1 of the house lights responds by quickly dimming on and off when we turn up intensity to full with generic dimmer fixtures in Vista set with address 101 - 108.
Logged

Cailen Waddell

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1427
Re: Anyone familiar with Cooper Industries LCR8A DMX lights?
« Reply #1 on: April 17, 2014, 09:23:57 pm »

You probably need to address them with RDM.
Logged

Mike McGuire

  • Newbie
  • *
  • Offline Offline
  • Posts: 5
Re: Anyone familiar with Cooper Industries LCR8A DMX lights?
« Reply #2 on: April 17, 2014, 10:15:05 pm »

You probably need to address them with RDM.

This fixture isn't that advanced.
Logged

Ray Cerwinski

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 78
Re: Anyone familiar with Cooper Industries LCR8A DMX lights?
« Reply #3 on: April 19, 2014, 11:26:40 pm »

Can you verify the model number on the actual LED driver?
Logged
Ray Cerwinski
Pages: [1]   Go Up
 


Page created in 0.057 seconds with 22 queries.