ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Community MX10  (Read 3591 times)

Weogo Reed

  • Full Member
  • ***
  • Offline Offline
  • Posts: 215
  • Western NC,
    • LiveEdge
Community MX10
« on: October 30, 2011, 09:54:44 pm »

Hi Y'all,

Anybody heard the Community MX10?

22#, 1.25" HF exit, crossover at 1000Hz.

Use would be modest-level monitor on lower-budget folk-music stages.

Thanks and good health,  Weogo
Logged

Weogo Reed

  • Full Member
  • ***
  • Offline Offline
  • Posts: 215
  • Western NC,
    • LiveEdge
Re: Community MX10
« Reply #1 on: January 11, 2012, 11:48:13 pm »

Bump - anybody have experience with this box?

Thanks and good health,  Weogo
Logged

Grant Conklin

  • Newbie
  • *
  • Offline Offline
  • Posts: 25
    • G-Force Pro Audio
Re: Community MX10
« Reply #2 on: October 29, 2012, 04:57:42 pm »

Hello Weogo,

I thought I'd resurrect your thread to see if others had experiences to share, and also to share a link with a real world review:  http://www.churchproduction.com/go.php/article/first_look_community_mx10_stage_monitor

I should point out that the dispersion is actually 100 degrees conical for the 10", not 115 as this article states.  I think the 8" is 115. 

I had been using FBT Verve 8m for small monitors, but they're being replaced by the Verve 108, which will be non-coax and not a wedge.  I think the mx10 might be just the ticket. 

Grant
Pages: [1]   Go Up
 


Page created in 0.055 seconds with 21 queries.