ProSoundWeb Community
Sound Reinforcement - Forums for Live Sound Professionals - Your Displayed Name Must Be Your Real Full Name To Post In The Live Sound Forums => Lighting Forum => Topic started by: wendelboe on December 28, 2019, 04:51:08 AM
-
Hi there.
I'm a soundtech, and has just done a soundinstallation, where i pulled a bunch of new DMX cable for upgrading the light-installation.
I was reccomended to do the dualpair for the most cost-effiency way, so as i understood, 1 cable=2 universes. But now im into the part where i'm goin to solder alle the connectors, and founding that the cable only have 1 shield and 2 pairs, so now im in doubt that i have been wrong in my understanding...
So my question summed up:
Can you split the screen in a typical doublepair DMX cable to run 2 universes, or can the cable only handle 1 universe?
Regards from the newbie ;-)
-
The 2 pairs can share the same shield, so you have 2 universes.
I would terminate in a small 2 d-hole box or mounting/wall plate.
-
The 2 pairs can share the same shield, so you have 2 universes.
I would terminate in a small 2 d-hole box or mounting/wall plate.
Great - then i have pulled enough cable under the floors!!!! it will all be connectede with neutrick 5P D-chassis in wall/floorboxes!
Thanks
-
Hi there.
I'm a soundtech, and has just done a soundinstallation,
Please go to your profile and change the "Name" field to your real first and last name as required by the posting rules displayed in the header at the top of the section, and in the Site Rules and Suggestions (http://forums.prosoundweb.com/index.php/board,36.0.html) in the Forum Announcements section, and on the registration page when you registered.
Mac
admin