ProSoundWeb Community
Sound Reinforcement - Forums for Live Sound Professionals - Your Displayed Name Must Be Your Real Full Name To Post In The Live Sound Forums => LAB Lounge => Topic started by: Bob Kidd on April 30, 2014, 11:35:23 PM
-
I have to replace internal crossover in srx 725 and ordered part. Has anyone done this before? If so is it easy to replace? Would rather save a little on having someone else do it. Thanks
-
I wouldn't think it would be that hard, just take the wires out of the old one and put in the new one, but make sure to note which wire goes to what driver beforehand. Also make sure it's the exact same crossover, kinda obvious but just to be sure.
Sent from my iPhone using Tapatalk
-
I wouldn't think it would be that hard, just take the wires out of the old one and put in the new one, but make sure to note which wire goes to what driver beforehand. Also make sure it's the exact same crossover, kinda obvious but just to be sure.
Thanks, no soldering involed?
Sent from my iPhone using Tapatalk
-
Nope, you unplug the connectors from the crossover to the drivers and also the input panel. No soldering needed.
Sent from my iPhone using Tapatalk