ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: QSC UF-3 and BSC-3 card removal  (Read 891 times)

gary green

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 254
QSC UF-3 and BSC-3 card removal
« on: January 06, 2008, 12:54:43 PM »

Anything I need to know about removing these cards so my amps behave as a stock amplifier?
I'm in the middle of a show and realized I have to go through this process in the nextr 24hrs with some CX amps I bought not remembering these were loaded w/ these cards -anything I need to be excited about before I dig in the manual and pop the tops off of these and begin??

Thanks!
Gary
Logged

Bob Lee (QSC)

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1788
Re: QSC UF-3 and BSC-3 card removal
« Reply #1 on: January 09, 2008, 12:27:16 PM »

If you're short on time you can just hit the bypass switches on the BSC-3. They're accessible through the side holes of the amp chassis; "out" is bypassed.
Logged
Bob Lee
Applications Engineer, Tech Services Group QSC Audio
Secretary, Audio Engineering Society
www.linkedin.com/in/qscbob

"If it sounds good, it is good."
 -Duke Ellington

ProSoundWeb Community

Re: QSC UF-3 and BSC-3 card removal
« Reply #1 on: January 09, 2008, 12:27:16 PM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.022 seconds with 19 queries.