ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]  All   Go Down

Author Topic: Light Clamps and Safety Cables  (Read 4459 times)

Karl P(eterson)

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1637
Re: Light Clamps and Safety Cables
« Reply #10 on: September 25, 2007, 11:47:12 PM »

Couple of different clamps for me.

On battens I like a good old standard Altman 510.

On truss I rather like the ProBurger 2" Snap Coupler

Occasionally a Micro-Clamp will be just the ticket.

Of course use safety* early and often....... (:

Karl P

*I meant safety cable! - What were you thinking?!

Note: Added more sarcasm..... Didn't think there was enough..........
TeamLeader.Technical Systems - CCH

Brian Ship

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 445
Re: Light Clamps and Safety Cables
« Reply #11 on: September 29, 2007, 12:37:48 AM »

safety cable always unless part of a lamp bar which as a bar gets a safety cable but individually is a sort of factory maintined gear for all the fixtures on the bar and does not persay need one each.

As for clamps, what ya clamping to more so determines what type of clamp is best to use.

Normal C-Clamps or others that send a bolt into say an aluminum at best pipe if not some form of thin gauge stand pipe is not going to be as efficient as other types that have either cheseborough or combination of the two sort of friction clamping to the pipe.  For steel pipe, no doubt a J-Clamp, G-Clamp, C-Clamp etc of many flavors.  For aluminum not so much without truss condom.

All dependant upon what you clamp to, for an I-Beam one thing, for lumber another, for pipe, depends upon what type of pipe.

Always safety cable individual fixtures without a doubt.
Pages: 1 [2]  All   Go Up

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.023 seconds with 13 queries.