ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Running mids at 8 or 4 ohms  (Read 1489 times)

Mike Constable

  • Newbie
  • *
  • Offline Offline
  • Posts: 13
    • http://www.twinaudiosolutions.com
Running mids at 8 or 4 ohms
« on: August 09, 2007, 03:28:13 pm »

I am currently upgrading my system size.  I currently have two three way mains.  I have an
1xEminence psd2002: highs
1xEminence Beta 12" High-mids
1xEminence kappa pro 15" Low-mids
in each.  I am going to get another pair of mains with same components to install.  
The current amps and ohms ran are as follows
horns 2x16ohm= 8ohms on on channel of pv1500
highmids 2x8ohms=4ohms one channel of pv1500
lowmids 2x8ohms=4ohms one channel of pv1500
subs 2x8ohms-4ohms bridged pv2600

My plan was to get two CS4000 for four subs running 4ohms bridged of each amp. Lowmids at 4ohms each channel of PV2600. Highmids at 4 ohms each channel of PV1500. And Highs at 8 ohms each channel PV1500



Any suggestions are welcome before I make the decision.
Logged

Jeff Babcock

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2313
Re: Running mids at 8 or 4 ohms
« Reply #1 on: August 10, 2007, 01:09:48 pm »

You may want to also look at the CS4080HZ - that might allow you to just run 1 sub amp instead of 2.  Regarding everything else, that looks ok, 4 ohms is nice and safe in stereo mode.
Pages: [1]   Go Up
 

Page created in 0.03 seconds with 19 queries.