ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: A quick isobaric/k question  (Read 2118 times)

Gareth James

  • Full Member
  • ***
  • Offline Offline
  • Posts: 231
A quick isobaric/k question
« on: November 10, 2006, 10:31:48 AM »

I did a search but couldn't find the info i need, when two drivers are loaded in an isobaric config, you need to double the MMS and BL correct?

Do you also then halve the RE since its two drivers connected parallel?

Using hornresp to sim something and this is confusing me... Confused
Logged

Michael_Elliston¶

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 261
    • http://www.geocities.com/xobt
Re: A quick isobaric/k question
« Reply #1 on: November 11, 2006, 05:38:18 PM »

if your isobaricing a horn driver,your probably wasting a driver.
Thesedays its better to just use one good driver IMHO.


Logged
Pages: [1]   Go Up
 

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.023 seconds with 19 queries.