ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: AMX/Panja Software?  (Read 3221 times)

Ray Cerwinski

  • Full Member
  • ***
  • Offline Offline
  • Posts: 136
AMX/Panja Software?
« on: February 21, 2006, 09:26:00 pm »

Does anybody have, or know of a place that I can get the programming and design software for the AMX remotes and system controllers? I am doing a system reconfiguration in a conference room with these installed, and the budget doesn't allow for all new control systems. If anybody can help me out, I'd really appreciate it.

Thanks
Ray Cerwinski
Logged
Ray Cerwinski

Fennelli Design Group
www.eventfx.com

Don Boone

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 782
Re: AMX/Panja Software?
« Reply #1 on: February 23, 2006, 01:45:12 pm »

Have you contacted AMX support at 800-222-0193?

Don
Logged

Ray Cerwinski

  • Full Member
  • ***
  • Offline Offline
  • Posts: 136
Re: AMX/Panja Software?
« Reply #2 on: February 23, 2006, 02:47:45 pm »

I haven't called them yet, but I have created an online account with them. After I login though, it won't allow me to access the software or remote templates. I'll try giving them a call in a little while. I'll let you know the outcome. I just figured it would be easier to locate someone who could would know of an alternative source for the software.

Thanks for your reply,
Ray Cerwinski
Logged
Ray Cerwinski

Fennelli Design Group
www.eventfx.com

Don Boone

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 782
Re: AMX/Panja Software?
« Reply #3 on: February 24, 2006, 10:49:03 am »

There are multiple versions of the software that may have been used to create the control program depending on the age and model # of the equipment. You should be able to retrieve the control program from the processor unless there wasn't enough space for the uncompiled version or the original dealer was a sleaze and didn't load it.

Unless you are pretty familiar with AMX you may do well to find an outside programmer.

Don
Logged

Rick Johnston

  • Full Member
  • ***
  • Offline Offline
  • Posts: 118
Re: AMX/Panja Software?
« Reply #4 on: February 25, 2006, 08:15:33 am »

Don Boone wrote on Fri, 24 February 2006 10:49

Unless you are pretty familiar with AMX you may do well to find an outside programmer.

Isn't that the truth! There are some things that are best left to the experts. An experienced programmer will do in a couple of hours what might take you weeks to figure out.

That's not to say you can't do it. But what's your time worth?

Logged
Pages: [1]   Go Up
 

Page created in 0.06 seconds with 20 queries.