ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]  All   Go Down

Author Topic: What Sawblades are you using?  (Read 3002 times)

Tim Padrick

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5008
Re: What Sawblades are you using?
« Reply #10 on: December 23, 2004, 10:30:28 pm »

40 teeth on an 8.5" blade would be about .67" per tooth or 1.5 teeth per inch.  60 teeth on a 10" saw would be about .52" per tooth or 1.9 teeth per inch - a small advantage to the 10".

At a given arbor speed, the 10" would run the teeth through about 19 percent faster than the 8.5", which would likely give a smoother cut if the feed rate is the same.  I expect that the motor would drag down less with a 10" than with an 8.5", widening the advantage of the 10".  
Pages: 1 [2]  All   Go Up
 

Page created in 0.054 seconds with 21 queries.