ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: am i missing something?  (Read 1546 times)

David Trotter

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 66
am i missing something?
« on: September 14, 2004, 04:05:13 am »

using the 18mm metric V2 designs and about to assemble the module. However, there are no measurments on the design that i can see which tell you how far apart the baffles go!?

Am i missing something, or do you just work it out from the size of a LAB12 and the flare pieces???

Al Limberg

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1482
Re: am i missing something?
« Reply #1 on: September 14, 2004, 09:04:22 am »

Seven (7) inches is the proper separation.
If the automobile had followed the same development cycle as the computer, a Rolls-Royce would today cost $100, get one million miles to the gallon, and explode once a year killing everyone inside - Robert X. Cringely
Pages: [1]   Go Up

Page created in 0.066 seconds with 20 queries.