ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: When building a pair...  (Read 2983 times)

Eric Wong!

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 880
When building a pair...
« on: May 20, 2004, 02:40:19 AM »

...should I do both a little at a time, or should I finish one and then do the other?  I'm thinking I should do both at the same time.  That way the 2nd one wont wind up looking 10x better then the 1st one.  I am excited about it though, hopefully I'll start next week.  
Logged

Marjan Milosevic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 681
Re: When building a pair...
« Reply #1 on: May 20, 2004, 04:10:57 AM »

Hi Eric,

This is how i did it and that is how most of the others seem did it to.

First cut all pieces for both labs.

First assemle both of the modules (you will loose most of the time on the modules) and then finish the first and then the second one.

Be careful to seal the chambers well.

Have fun

MarjanM
Pages: [1]   Go Up
 

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.031 seconds with 21 queries.