ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Drive Rack setting for LAB Subs  (Read 2970 times)


  • Newbie
  • *
  • Offline Offline
  • Posts: 4
Drive Rack setting for LAB Subs
« on: April 30, 2004, 04:50:31 pm »

 I am in the initail stages of building a pair of subs and would like if  anyone has come up with a PEQ setting for the lab subs with the drive rack PA. I will be driving them with a pair QSC PLX 3002's


  • Full Member
  • ***
  • Offline Offline
  • Posts: 131
Re: Drive Rack setting for LAB Subs
« Reply #1 on: May 01, 2004, 11:46:00 pm »

I see a Problem for you,  Typical settings for delaying your mid cabs to your Labs is about 10.5 ms ave. then you have the high tops if your running 3 way, maybe another 3-8ms depending.  Smaart will let you know this info, beg borrow or rent it if need be. the DriveRack PA only offers 10 ms total delay. thats it.  I d suggest you upgrade to the 260.  it has i beleive 2.3 seconds total of delay time available, this will solve your possible prob.  If on the other hand, you have 2 way tops with a passive xover, you may be able to move your tops around on top of your labs, while using smaart to get the desired results. id sell the PA, move it to the small rack/monitor rack n get the 260 for FOH. Just my opinion. Good Luck!
I had to do it cuz I'm Just like that!!!!!
Pages: [1]   Go Up

Page created in 0.087 seconds with 18 queries.