Church and H.O.W. Forums for HOW Sound and AV - Your Displayed Name Must Be Your Real Full Name To Post In The Church and HOW Forums > Church Sound Archive

Mic'n Drums with Shield?

(1/6) > >>

Joe Long:
Hows it goin,

So we're in the process of getting a drum shield, (much needed) and I was curious as to if we should mic them too?
Someone mentioned we should.
I was hesitant about it, especially with the plan they had....

Attached is a picture of what/where are drums are...the shield is just a norm shield I guess, 3 panels.


drums go in clear back centered

Anyway someone said we should just use a spare portiable mixer we have in the back and plug all the mics in there that way the drummer can control his own mics??? and then send one signal to the soundboard?

Thoughts on this?
Thanks?

Ron Balsom:
Welcome Jarron,  you have a typical drum question so you'll probably get allot of response.  It appears to be a small worship area, and unless there's a 'strong' comtemopary group, micing the drum set could be a minimal effort.  I speak only as a FOH tech. position. I'm not a musician either. I'm assuming the option of 'electronic drums' has been considered??  Most drummers who are new to the church worship experience, tend to just play what I call 'playing the full kit' all the time. There's that 'gentle touch' needed that varies with the worship experience.  You'll find additional threads here about drum shields with the ideal type of material to be used.  Personally, I would use a Conderser type of mic as an 'overhead' mic and use your judgment from there.  You can always add in a 'kick' and 'snare' as needed.  Perhaps consider a tall shield say 6' or more.  Keep us posted.  Blessings,  Ron Balsom  HPCC  Casper, Wyoming.  

Joe Long:
I forgot to mention
our drummer loves to play(loud)

and electric drums - no
thanks for the reply

still could use some input

Justin Langman:
I love the sound of mic'd up drums, so I would be micing them up!

My philosophy I guess you would say, (small church as well), is to enclose the drums and then mic them, giving the FOH engineer control over the sound and volume, so they can actually 'mix' the drums.

Enclosing the drums also greatly lowers your stage volume, singers can hear themselves better, you can turn down the wedges, which again improves the house mix. So the benfits are many.

If you are short on mic lines to your FOH position, or channels on your board, then you will need to submix - plug all the drum mics into a mixer on stage, (or your booth), set up the drums mix there, and feed a mono, (or stereo if you want), drums mix back to your main board. You could also send selected channels direct to your main board, say kick + snare + mix if you like. Edit: You do NOT want to give the drummer control over this. You want to set the mix of the drums and then that's it for the day/service. (unless there's a problem you need to fix/adjust)

Looking at your stage, to get the most benefit, you will want some sort of absorption on the wall behind to drums, otherwise most of the sound will be reflected into the room anyway.

Hope this is helpful. Justin.

Joe Long:
Hey Justin, thanks for the reply

So youre saying NOT to have that submix? only if needed?

and to not give control to the drummer, just for my own curiousity (mainly to also back up what i say) why shouldnt you give the drummer control

And yes i believe the FOH should be the one mixing the drums being as we hear it...

However, currently we dont have enough channels on our board (not cables) channels...so submixing is maybe what we would do...but would you lose quality?
this is still kinda hazy to me.
thanks to anyone who helps!

Navigation

[0] Message Index

[#] Next page

Go to full version