Sound Reinforcement - Forums for Live Sound Professionals - Your Displayed Name Must Be Your Real Full Name To Post In The Live Sound Forums > LAB Subwoofer Forum

project tops 2x10 inch with kappa pro 10lf+driver 2 inch psd 3006

(1/2) > >>

Ionescu Florin Gabriel:
Howdy !

I would like to do a 2x10 inch project with eminence kappa pro 10lf+driver 2 inch eminence psd 3006.

I want 2 pieces to put on top of 4 pieces 2x12 LAB 12. Do you think this combination is ok considering that I will tune them to 60-70 hz?

Tim Weaver:

--- Quote from: Ionescu Florin Gabriel on May 02, 2023, 03:51:02 AM ---Howdy !

I would like to do a 2x10 inch project with eminence kappa pro 10lf+driver 2 inch eminence psd 3006.

I want 2 pieces to put on top of 4 pieces 2x12 LAB 12. Do you think this combination is ok considering that I will tune them to 60-70 hz?

--- End quote ---

It would make noise, and if you are good at tuning, it would probably sound pretty good. But there's no way for us to know if it would fill your needs or not.

https://soundforums.net/community/ Is much more involved with DIY PA cabs. Peter Morris is very active over there and he really knows his stuff.

Ionescu Florin Gabriel:

--- Quote from: Tim Weaver on May 02, 2023, 11:13:38 AM ---It would make noise, and if you are good at tuning, it would probably sound pretty good. But there's no way for us to know if it would fill your needs or not.

https://soundforums.net/community/ Is much more involved with DIY PA cabs. Peter Morris is very active over there and he really knows his stuff.

--- End quote ---

Ok, thank you very much for everything!

Mike Caldwell:
That would make a rocking system.
I would go a little higher on the high pass for the 10's.
What horn are you going to use with the drivers?

The system will need some DSP processing tweaks.
You will need to do some delay off set for the 10's to compensate for the LAB sub horns.

Ionescu Florin Gabriel:

--- Quote from: Mike Caldwell on May 03, 2023, 02:58:00 PM ---That would make a rocking system.
I would go a little higher on the high pass for the 10's.
What horn are you going to use with the drivers?

The system will need some DSP processing tweaks.
You will need to do some delay off set for the 10's to compensate for the LAB sub horns.

--- End quote ---

I don't want to make a chimney enclosure for them, but a ventilated box with tuning 70-80 hz because I will cut the labs to 80-100hz and from here they will take kappa, but if it goes tuned higher, at what frequency would it go the best?


Navigation

[0] Message Index

[#] Next page

Go to full version