ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: Crown CDI 2000 Output levels not matching input levels  (Read 2726 times)

Tim McCulloch

  • SR Forums
  • Hero Member
  • *
  • Online Online
  • Posts: 23775
  • Wichita, Kansas USA
Re: Crown CDI 2000 Output levels not matching input levels
« Reply #10 on: August 31, 2021, 09:06:34 AM »
Quote from: Lee Buckalew on August 30, 2021, 12:14:31 PM
Jose, Tim is usually correct when pointing out things like this but the "bridge" symbol shows as the OUTPUT MODE icon no matter what mode is selected.
The CDi series would be showing a single channel if set to Bridge mode. 
This is a two channel amp set to a two channel mode.

Lee

Guess I should have loaded the amp profile in Audio Architect and took a look...

At this point, without having the amp in front of me, I'm not sure where to point.  A call to Crown would be in order.
Logged
"If you're passing on your way, from Palm Springs to L.A., Give a wave to good ol' Dave, Say hello to progress and goodbye to the Moonlight Motor Inn." - Steve Spurgin, Moonlight Motor Inn

ProSoundWeb Community

Re: Crown CDI 2000 Output levels not matching input levels
« Reply #10 on: August 31, 2021, 09:06:34 AM »

Pages: 1 [2]  All   Go Up
« previous next »
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.035 seconds with 24 queries.