ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: DMXIS and selecting "Basic Shapes"  (Read 1629 times)

Sam Costa

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 481
  • 408-849-6420
DMXIS and selecting "Basic Shapes"
« on: December 10, 2020, 02:40:06 PM »

Hello all,
I currently have several of the "Chinese 230 watt 7R" and so far they have been working pretty good for a year. My question is, on the DMXIS program (Show buddy) I've been using my own personal oscillators and adjusting them manually, however I would like to use the "basic Shapes" section to some of the moving fixtures I have.

I've selected the PAN and TILT channels, clicked on Macros, then selected Basic Shapes, then selected Circle (I've also selected Diamond, Triangle, figure 8 and etc,  and it doesn't do anything after that..
Am I missing a step? did I do something wrong?

Any help would be greatly appreciated.
Thanks.
-Sam
« Last Edit: December 10, 2020, 02:55:14 PM by Sam Costa »
Logged
Being a productive member of society and encouraging others to do the same.

ProSoundWeb Community

DMXIS and selecting "Basic Shapes"
« on: December 10, 2020, 02:40:06 PM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.029 seconds with 23 queries.