Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[David Sturzenbecher]

With the Meyer Compass Software, do you have to be connected to actual equipment to do anything?   If I show the Galileo tab, add a processor, I can see the grayed out settings, but even in "virtual" mode they are grayed out. Likewise with the CAL tab...all grayed out controls.

[John Sulek]

With the Meyer Compass Software, do you have to be connected to actual equipment to do anything?   If I show the Galileo tab, add a processor, I can see the grayed out settings, but even in "virtual" mode they are grayed out. Likewise with the CAL tab...all grayed out controls.

You do not need to be connected to any physical hardware.
Under the "devices" tab, click on the "use virtual" button of the device you have added that you wish to program. It should show "connected" after a short pause. Then you are set to start programming.

[David Sturzenbecher]

You do not need to be connected to any physical hardware.
Under the "devices" tab, click on the "use virtual" button of the device you have added that you wish to program. It should show "connected" after a short pause. Then you are set to start programming.

Hi John,
Thanks for the reply.  When i click "Use Virtual" it says ERROR in that block, and the Connecting and Status field just say "connecting".  Weird.

[John Sulek]

Hi John,
Thanks for the reply.  When i click "Use Virtual" it says ERROR in that block, and the Connecting and Status field just say "connecting".  Weird.

Hmmm. I just tried it again on Compass. Deleted all the virtual Galileo devices already there, added one and connected and disconnected a few times with the "use virtual " button.
It has been a while since I used this software regularly, but I don't remember any problems using the offline editor.
Sorry I can't point to the problem.

[Matthias McCready]

Hi John,
Thanks for the reply.  When i click "Use Virtual" it says ERROR in that block, and the Connecting and Status field just say "connecting".  Weird.

Do you need to be logged in? I know in MAPP that is a thing.

[David Sturzenbecher]

Hmmm. I just tried it again on Compass. Deleted all the virtual Galileo devices already there, added one and connected and disconnected a few times with the "use virtual " button.
It has been a while since I used this software regularly, but I don't remember any problems using the offline editor.
Sorry I can't point to the problem.

Hi John,
Deleting all the Galileo devices already there, then adding one back in seems to have done the trick.  Weird, but thanks again.

[ProSoundWeb Community]