Topic: 3 (Three) Phase Distro tied into single phase (split-phase) supply (Read 8704 times)

Jonathan Johnson · « **Reply #30 on:** December 10, 2019, 01:41:25 AM »

The reason for not tying the neutrals together at the load end is because, unless they are very closely matched in resistance, any imbalance in resistance will result in a current imbalance, which could result in one of the neutrals being overloaded.

And, in a camlock setup, if one of the neutral cams should become disconnected, the other neutral could be overloaded.

ProSoundWeb Community · « **Reply #30 on:** December 10, 2019, 01:41:25 AM »

ProSoundWeb Community

Author Topic: 3 (Three) Phase Distro tied into single phase (split-phase) supply (Read 8704 times)

Jonathan Johnson

Re: Fully power 3 phase distro on single phase power?

ProSoundWeb Community

Re: Fully power 3 phase distro on single phase power?