ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: PA Power amp Connection Question  (Read 474 times)

Dennis Wiggins

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 727
Re: PA Power amp Connection Question
« Reply #10 on: November 29, 2019, 10:15:45 am »

...The mixer has a L & R main output. The NX4 has A,B,C,D input and 4 channels out (ABCD). How do I connect the L & R out to the power amp input and have A, B, C, and D outputs with independent volumes on each?...

Look at the right side of page 5 of the manual that came with the NX4-6000.

Set both of the switches to "stereo."  This will be the 4 input to 4 output configuration.

Set both switches to "full range."

Use 2 Y cables to "split" each L and R output from you mixer.
(Buy 2 of these:  Hosa YXM-101.5 XLR3F to Dual XLR3M Y Cable, 1.5 Feet)

Plug the 2 split outputs from L into the A and B inputs, and the 2 R into the C and D inputs.

You will now have individual control of each of the amp channel volumes.

A and B knobs will individually control the L signal outputs.  C and D will control the R.

-Dennis

 
« Last Edit: November 30, 2019, 04:34:51 pm by Dennis Wiggins »
Logged

Mac Kerr

  • Old enough to know better
  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6604
  • Audio Plumber
Posting Rules
« Reply #11 on: November 29, 2019, 11:07:01 am »

I agree.

Please go to your profile and change the "Name" field to your real first and last name as required by the posting rules displayed in the header at the top of the section, and in the Site Rules and Suggestions in the Forum Announcements section, and on the registration page when you registered.

Mac
admin
Logged

ProSoundWeb Community

Posting Rules
« Reply #11 on: November 29, 2019, 11:07:01 am »


Pages: 1 [2]  All   Go Up
 



Page created in 0.044 seconds with 23 queries.