ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Difference between CS6364 and SS2-50R  (Read 4852 times)

Bob Faulkner

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1502
  • Raleigh, NC
Difference between CS6364 and SS2-50R
« on: May 02, 2019, 01:53:38 PM »

Looking for a few short 50amp pig-tales.

Some have either a CS6364 female end or an SS2-50R female end.  From the online photos I'm using to research what I need, the CS and SS2 ends (the actual ends) look identical.  However, the drawings of the CS6364 always seem to represent the center hole for the guide pin.  The SS2-50R drawing does NOT reference a guide hole, however, the SS2-50R pictures shows a guide hold.

Are they the same ends?

Looks like maybe the SS2-50R end uses an 8ga green wire and locks to the mating component with a collar.



« Last Edit: May 02, 2019, 02:01:18 PM by Bob Faulkner »
Logged

Bob Faulkner

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1502
  • Raleigh, NC
Re: Difference between CS6364 and SS2-50R
« Reply #1 on: May 02, 2019, 02:21:17 PM »

hmmm... looks like those are the differences between them.  The locking mechanisms are different. 
Logged

ProSoundWeb Community

Re: Difference between CS6364 and SS2-50R
« Reply #1 on: May 02, 2019, 02:21:17 PM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.025 seconds with 22 queries.