ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 2 [3]  All   Go Down

Author Topic: DMX lighting bypass DMX Wall Controller  (Read 1401 times)

Scott Hofmann

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 315
Re: DMX lighting bypass DMX Wall Controller
« Reply #20 on: November 08, 2019, 09:58:38 am »

Also remember that you will need to incorporate a power supply for the Fleenor box!
Logged
Scott Hofmann

Alain Bouit

  • Newbie
  • *
  • Offline Offline
  • Posts: 6
Re: DMX lighting bypass DMX Wall Controller
« Reply #21 on: November 08, 2019, 10:55:31 am »

Also remember that you will need to incorporate a power supply for the Fleenor box!

Thanks so much for all the great technical help. Much appreciated! I'll post an update on how it goes.
Logged

Scott Hofmann

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 315
Re: DMX lighting bypass DMX Wall Controller
« Reply #22 on: November 13, 2019, 05:28:15 pm »

Thanks so much for all the great technical help. Much appreciated! I'll post an update on how it goes.

You might make certain the UFR2-LV can drive however many of the chandeliers you are going to use.
From the ETC cut sheet: "Independent control for 0-10V fluorescent ballasts and/or LED drivers, each (of the two outputs) is capable of sinking 100mA".
What is the milliamp requirement for each of your fixtures? Just a thought. I've never dealt with LED 0-10v dimming.
Logged
Scott Hofmann

ProSoundWeb Community

Re: DMX lighting bypass DMX Wall Controller
« Reply #22 on: November 13, 2019, 05:28:15 pm »


Pages: 1 2 [3]  All   Go Up
 



Page created in 0.064 seconds with 24 queries.