Think I’m throwing in the towel on QLC+. Trying to figure out the bits and pieces of Onyx. Do I need to buy a controller or will this run off my win 10 laptop and eDMX 1 Ethernet to dmx/artnet box.
The controllers M-Touch and M-DMX look pretty cool. Any thoughts there ?
This is Martin's M-PC software rebranded after it was sold to elation correct?
If memory serves correctly this is the case and I have been using the Obsidian website to figure out M-PC (which is yes out dated, as is the computer its running on). If this is the case I think they are roughly the same program,
My understanding is that downloads are free and that it will work with non-proprietary hardware, although they of course hope you will buy into their hardware.
As someone who is fairly new to DMX and who is not an LD by any means I found it very easy to program and used for a small install a few months back. I like that the software can be configured however you want for the end user. I have it setup so it loads to a snapshot (playback or cue scenes is the technical term I think), so it does not give edit access to the user.
Basically when the software is loaded the user has about 10 presets that can be chosen from.
I would use the software again, granted I am not an LD and I have not head to mess with movers at all; so take all of this with a grain of salt.