ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: 230watt 7R moving head - bulb?  (Read 870 times)

Don T. Williams

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 704
  • Midas Pro 1 & 2, M32, dbTech T12, T8, S30, DM12
    • Q Systems Music & Sound
Re: 230watt 7R moving head - bulb?
« Reply #10 on: January 04, 2019, 06:04:50 pm »

Some Chinese fixtures don't come with much in the way of (or any) instructions.  If this is the case, raising a specific fader may signal a lamp to turn off (or on to restart) at a specified DMX level.  It is usually a fader at or near the end of the chain of control faders.  I've had customers bring lights in with that "feature" (or problem) that they didn't know about.  I've also seen a lot of problems with the nylon covered "butt" crimp connectors, especially those located in the moving yolk portion of the light.  The connector wasn't crimped tightly enough and some wires pull out with a very light touch.
Logged

Joel T. Glaser

  • Newbie
  • *
  • Offline Offline
  • Posts: 16
Re: 230watt 7R moving head - bulb?
« Reply #11 on: January 06, 2019, 04:26:40 pm »

Hey Sam. Is it possible your lights have a cool down setting? My big Chauvet movers have a setting for shutting off the lamp while the fans continue to run so as to cool the lamp down before shutting the unit completely off. Supposed to extend the life of the lamps.

Even if your movers have this setting, not sure how it would have gotten into that setting without you doing it.

Just a thought.
Logged
Pages: 1 [2]  All   Go Up
 


Page created in 0.037 seconds with 23 queries.