ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Crown XTi 6002 Security Cover  (Read 1126 times)

Robert Weaver

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 54
Crown XTi 6002 Security Cover
« on: March 01, 2018, 09:44:00 pm »

I ordered a security cover for the Crown XTi 6002 amp.  Upon installing the cover I discovered the cover doesn't fit due to the pullout handles of the 6002.  Does anyone know of a cover that will work?
Logged

Mike Caldwell

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1410
  • Covington, Ohio
    • Mike Caldwell Audio Productions
Re: Crown XTi 6002 Security Cover
« Reply #1 on: March 01, 2018, 10:17:24 pm »

I ordered a security cover for the Crown XTi 6002 amp.  Upon installing the cover I discovered the cover doesn't fit due to the pullout handles of the 6002.  Does anyone know of a cover that will work?

You can lock out the front panel menu buttons using the System Architect or Band Manager, but someone can still turn the knobs.

To put a security covers over equipment with handles a couple times like an XTI amp I used longer 10/32 screws, cut the heads off and used a nut to tighten up to the piece of equipment and double nuts to hold the security cover, not real elegant but it worked. If I was doing a lot of those I would some threaded studs with male threads to screw into the rack and female threads on the other end to screw the cover to.

Robert Weaver

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 54
Re: Crown XTi 6002 Security Cover
« Reply #2 on: March 01, 2018, 10:28:23 pm »

You can lock out the front panel menu buttons using the System Architect or Band Manager, but someone can still turn the knobs.

To put a security covers over equipment with handles a couple times like an XTI amp I used longer 10/32 screws, cut the heads off and used a nut to tighten up to the piece of equipment and double nuts to hold the security cover, not real elegant but it worked. If I was doing a lot of those I would some threaded studs with male threads to screw into the rack and female threads on the other end to screw the cover to.

Some 10-32 hex standoffs with a washer might work if they were long enough.
Logged

ProSoundWeb Community

Re: Crown XTi 6002 Security Cover
« Reply #2 on: March 01, 2018, 10:28:23 pm »


Pages: [1]   Go Up
 



Page created in 0.042 seconds with 22 queries.