Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Timothy Bolish]

Hey all,

Did some searching in the forums but couldn't find a definitive answer. I'm an complete amateur when it comes to networking so please bear with me.

Currently onsite at a gig where I'm connecting to my QL1 with a N600 router.  Lots of different zones in different rooms, so I tried to extend the range of my router by using a little portable TPLink travel router.

I set it up (TPLink router) as a repeater, entering the SSID, MAC address, and security info for the N600...couldn't get it to work with stage mix. For that matter, I wasn't even sure if I was connecting the to TPLink at all...is this possible and is there an easy way to monitor if I'm connecting to the network via the TPLink repeater or if I'm connecting via the N600?

Thanks!


Sent from my iPhone using Tapatalk

[Jean-Pierre Coetzee]

Hey all,

Did some searching in the forums but couldn't find a definitive answer. I'm an complete amateur when it comes to networking so please bear with me.

Currently onsite at a gig where I'm connecting to my QL1 with a N600 router.  Lots of different zones in different rooms, so I tried to extend the range of my router by using a little portable TPLink travel router.

I set it up (TPLink router) as a repeater, entering the SSID, MAC address, and security info for the N600...couldn't get it to work with stage mix. For that matter, I wasn't even sure if I was connecting the to TPLink at all...is this possible and is there an easy way to monitor if I'm connecting to the network via the TPLink repeater or if I'm connecting via the N600?

Thanks!


Sent from my iPhone using Tapatalk

Ping the N600's ip address or try to connect to the Web GUI from the ipad.

This would usually be in the 196.0.x.x range or the 10.0.x.x range.

[Geert Friedhof]

Repeaters should be banned. They create more problems than they solve. If you can only create a wireless link get a few Ubiquiti Unifi Mesh accesspoints.

[ProSoundWeb Community]