ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: How much power do i need to drive these power hungry Powerlight Amplifiers???  (Read 6339 times)

David Sturzenbecher

  • Hero Member
  • *****
  • Online Online
  • Posts: 1968
  • So. Dak.
    • Sturz Audio

Thanks,

Am sure the generator would handle water heater kind of loads close to its capacity but the peak draw from powerlights is definitely way way higher than the rms draw.
Conrad
Didn't you say you had PLX amps?

The powerlight series of amps from QSC is a quality notch above the PLX and doesn't typically suffer from these issues.


Sent from my iPhone using Tapatalk Pro
Logged
Audio Systems Design Engineer
Daktronics, Inc.
CTS-D, CTS-I
AES Full Member

Conrad Muzoora

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 267
  • Mbarara, Uganda. www.koolinvestments.co.ug
    • Kool Events Uganda

Didn't you say you had PLX amps?

The powerlight series of amps from QSC is a quality notch above the PLX and doesn't typically suffer from these issues.


Sent from my iPhone using Tapatalk Pro

Thanks for the observation,
I kind of use powerlight to mean qsc's switching amps. In this case was a mixture of plx and CX series, in my opinion identical amps with a few different feature sets but same amp modules. I tried a powerlight PL236 once and couldn't tell any difference between it and the plx 3602.
Conrad
Logged

ProSoundWeb Community


Pages: 1 [2]  All   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.033 seconds with 25 queries.