Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Matt Greiner]

I will look into that table as a reference point, thank you Tom. For clarification this is not a 5 wire configuration, it is single phase.  It would be two or three depending on if the neutral counts.

[Rob Spence]

I will look into that table as a reference point, thank you Tom. For clarification this is not a 5 wire configuration, it is single phase.  It would be two or three depending on if the neutral counts.

Also, consider both the actual expected load and the distance. I use 10-4 for my amp rack but it is only 10’ and I know I never exceed 20a (have run on 2 20a circuits).



Sent from my iPad using Tapatalk Pro

[Tim McCulloch]

10 gauge work for the 30 amps?  Or should I up it to 8 gauge?

I *really* like #8 for 30 Amp circuits if the cable is over 25 ft.  I routinely over-size conductor specifications to minimize voltage drop.

Our arena rigs have #8-5 loomed with the drive snakes for FOH power.

[Riley Casey]

For all those times you take out the XL3 with dual hot PSUs and two double wide racks of outboard.  When's the last time you put a current clamp on the power lines going to FOH?

I *really* like #8 for 30 Amp circuits if the cable is over 25 ft.  I routinely over-size conductor specifications to minimize voltage drop.

Our arena rigs have #8-5 loomed with the drive snakes for FOH power.

[Tim McCulloch]

For all those times you take out the XL3 with dual hot PSUs and two double wide racks of outboard.  When's the last time you put a current clamp on the power lines going to FOH?

It was the PM4000, but close enough!  These days it could be a run of 12-3 and eventually it might be just that.  The 250' of 8-5 might become amp rack power cables for our next rig....

[TJ (Tom) Cornish]

These days it could be a run of 12-3 and eventually it might be just that. 

The large (for me) power distro order I just placed is largely for L14-20 distribution (and a couple Cali's).  What I like about L14-20 is you can use 12/4 wire, get either 2 120v or one 208v circuit per cord, and no downstream circuit breakers needed. 

IMO the various 30A standards are outdated - pretty much anything that requires more than 20A at 120v runs better at 208v anyway, and the 30A size is awkward for a lot of things - not large enough for two heavily loaded 20A circuits per leg, additional cable size requirements, large/expensive breakout boxes, etc. 

[ProSoundWeb Community]