Topic: Line 6 XD-V75 for Wireless Measurement (Read 6444 times)

Chris Eddison · « **Reply #10 on:** November 28, 2017, 09:39:13 am »

I've got to add my 8 channels of V70/V55 to the list of Line6 woes in this thread.

I've had to modify both my aerials as the connectors are very fragile. Have one beltpack that I can only describe as occasionally going "rogue" - lots of noise on the channel and seems to bleed across on to adjacent mics (yes they're all in the same RF mode). Had to replace the battery door on 2 as the catch broke. Had to replace the board with the led's and buttons on as I had a battery get stuck and then burst in the very tight battery bay, bleeding gunk everywhere. Most recently one of the 4 pin mini xlr sockets snapped way down in the barrel. They're very flimsy plastic and i'm not overly surprised. Also most of my 4 pin mini xlr sockets now don't latch properly.

It's such a shame. They made a great sounding wireless system with loads of potential, but reliability just let it down. RF performance has always been rock solid too although it's still a but disconcerting to completely lose a channel as somebody leaves the stage and goes in to a dressing room, and makes for a stressful time before a show hoping that you can't see RF because they're through a wall, not because their pack has died!