ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Shure ANI4IN-XLR & ANI4OUT-XLR Dante Interfaces  (Read 898 times)

TomBoisseau

  • Full Member
  • ***
  • Offline Offline
  • Posts: 199
Shure ANI4IN-XLR & ANI4OUT-XLR Dante Interfaces
« on: March 09, 2017, 08:56:36 pm »

I was wondering if anyone here had personal experience using the Shure ANI4IN-XLR or ANI4OUT-XLR Dante interfaces? Specifically, I would be using them with a Yamaha QL5, and I'm wondering if there will be any way to directly access the "trims" from the console or from Dante Controller?

Thanks,
Tom

Logged

Mac Kerr

  • Old enough to know better
  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6508
  • Audio Plumber
Re: Shure ANI4IN-XLR & ANI4OUT-XLR Dante Interfaces
« Reply #1 on: March 09, 2017, 09:16:36 pm »

I was wondering if anyone here had personal experience using the Shure ANI4IN-XLR or ANI4OUT-XLR Dante interfaces? Specifically, I would be using them with a Yamaha QL5, and I'm wondering if there will be any way to directly access the "trims" from the console or from Dante Controller?

Thanks,
Tom

Not from Dante Controller, Audinate does not want to deal with lots of manufacturer's protocols, but maybe from Shure if they sell enough of them, they did work out the interface for the ULXD and QLXD mics, and the Yamaha control will be the same.

Mac
Logged
Pages: [1]   Go Up
 


Page created in 0.022 seconds with 23 queries.