The information looks practical enough and is a very useful GUIDE to the right path. Keep in mind the results shown are going to be with the equipment and the processing used in the graphs. So while the results would be TYPICAL, they will not be exact. In general the orientation and processing of the speakers will result in a measurably reliable result. So take it as just that, a guide to the likely result with that configuration and processing. Many speakers now have a prediction software that can be used to array them and find an appropriate coverage. As with anything in sound, it is a matter of interpretation and implementation to get the desired results. The projected outcomes are not perfect, but can get you most of the way there.
Thanks, I feel that I have a firm grasp on the fundamental concepts of sub arrays. I've been keeping up with the other sub array threads to pursue a better understanding. I'm pretty solid on understanding that most of what I read and when I see models is unlikely to translate into real life perfectly. I look at models and read what others have done to see a Trend for a specific concept instead of attempting to duplicate (conceptually) a different environment with different gear falsely assuming to arrive at the same exact point.
What I feel I lack in understanding arrays is how to properly setup the acoustic crossover interaction between the arrays and the mains. Following the premise that a full range point source sounds best and knowing that is physically impossible. Imagine this scenario. (perhaps the attached image will help too)
A sub and a main flown to simulate a point source thus easiest to setup crossover (phase align should be easy right?) [time align easy as both LF+HF emanate from same source].
VS
A main flown and subs ground stacked into an array or just combined or whatever. (phase aligning is difficult) and [time align is hard because only good for small group of people].
Is this system tuning where programs like SMAART come in?
When does being on point with crossover tuning really start/stop to matter?
If you're interested in deepening your understanding consider reading this 72 page document.
Regards,
Merlijn
Thanks for that! I've already read a couple of articles and I found it quite enlightening.