ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: ElectroVoice CPS2T 70 Volt Bridging  (Read 1991 times)

William Power

  • Newbie
  • *
  • Offline Offline
  • Posts: 6
ElectroVoice CPS2T 70 Volt Bridging
« on: January 24, 2013, 09:42:13 AM »
I guess it's not possible to bridge the outputs of a EV CPS2T. If bridged the way the manual specifies, it would be 50v vs. 70v. Does anyone out there know different?
Logged

Brad Weber

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2208
  • Marietta, GA
Re: ElectroVoice CPS2T 70 Volt Bridging
« Reply #1 on: January 24, 2013, 12:41:21 PM »
Quote from: William Power on January 24, 2013, 09:42:13 AM
I guess it's not possible to bridge the outputs of a EV CPS2T. If bridged the way the manual specifies, it would be 50v vs. 70v. Does anyone out there know different?
There are two separate, transformer derived 25V/70V/100V outputs which can be aa single 50V/140V/200V output, respectively, if the amp is run as bridge mode.  However, in bridge mode you also have a direct output rated 1,200W into 8 Ohms that should be capable of direct driving a 70V system.
Logged

ProSoundWeb Community

Re: ElectroVoice CPS2T 70 Volt Bridging
« Reply #1 on: January 24, 2013, 12:41:21 PM »

Pages: [1]   Go Up
« previous next »
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.027 seconds with 24 queries.