ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: HELP with SW218V problem!!  (Read 1628 times)

Joe Ellis

  • Newbie
  • *
  • Offline Offline
  • Posts: 1
HELP with SW218V problem!!
« on: April 29, 2012, 11:17:46 am »

Hello all...long time lurker here, but need help for the first time...thanks in advance!

I have three Yamaha sw218v cabs.  When I pulled on out of storage for the winter, it was dead.  If I run a full range signal to the cab I can hear a TINY bit of high frequency, but no lows and it's almost inaudible it is so quiet.  If I run a signal through a cross over...there's nada.

I pulled all the covers and inspected all wiring and there is no damage.  I swapped the drivers with a couple from my working cabs and the prob still persists (the drivers work fine in the other cabs). 

I see a capacitor or something in line with the hot wires but it appears fine...could that be the issue?  It is about the only thing left!  If so, I cannot seem to find anywhere that I could simply buy that part to replace, or buy a complete set of wiring from the panel in....

Thanks again for your help!

Joe.e
www.joeellismsic.com
Logged
Joe.e
Proudly supporting Sennheiser and
The Flying Musicians Association
www.joeellismsusic.com

ProSoundWeb Community

HELP with SW218V problem!!
« on: April 29, 2012, 11:17:46 am »


Pages: [1]   Go Up
 



Page created in 0.111 seconds with 22 queries.