ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 2 3 [4]   Go Down

Author Topic: sub output not equal  (Read 15600 times)

g'bye, Dick Rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7424
  • Duluth
Re: sub output not equal
« Reply #30 on: November 19, 2011, 02:34:33 pm »

Page 16 of the manual tells the OP all he needs to know about the speakon connections relating to the amp.

Thanks for the clarification, Bob.  I only got as far as page 11 when looking for an explanation.
Logged
Pay no attention to the man behind the curtain...

Bob Leonard

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6807
  • Boston, MA USA
Re: sub output not equal
« Reply #31 on: November 20, 2011, 06:06:21 pm »

It's not clear at all Dick. The manual has nothing in writting that referes to the connections, only the diagram which is easy to overlook.
Logged
BOSTON STRONG........
Proud Vietnam Veteran

I did a gig for Otis Elevator once. Like every job, it had it's ups and downs.

Poopedi Kwena

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 54
Re: sub output not equal
« Reply #32 on: November 22, 2011, 07:53:05 am »

I have used a similar setup before, and surprisingly it happens on some days while on others it does not. In my case I attributed the problem to the mode switch at the back of the Subs. Some are designed with internal XO's such that if you daisy chain 2 subs, the second sub will be in the bandpass frequency and that may have a lesser punch.

In other days I found that phase was the problem then the final solution was 2 giv up the bridge mode and run each sub from its own amp channel 
Logged

ProSoundWeb Community

Re: sub output not equal
« Reply #32 on: November 22, 2011, 07:53:05 am »


Pages: 1 2 3 [4]   Go Up
 



Page created in 0.019 seconds with 21 queries.