Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Bharat Bajaj]

Dear Friends,
                    Ive a Nexo Geo S12 set up with RS18 Subs. ^a side with 2 subs each. Powered by Camco V200 for Geo S & V6 for sub bass.
 
The problem I face is the compression put in automatically by the NX242 controller. Though it shows a lot of head room still the system gets compressed a lot. secondly , the Amplifiers are not cliping .
          Kindly suggest what i might be doing wrong.


Thanks,


Bharat Bajaj

[Tim McCulloch]

The first thing that comes to mind is an incorrect amp gain setting in the controller.

[Gareth Marsh]

You need to read the sections in the manual about amplifier gain and power and set them according to the instructions. Also;

-Might pay to check your sense wiring polarity at the same time.

-Set the headroom value to suit your mixer


HTH

Gareth

[Doug Fowler]

Polarity on the sense lines does not matter.

[Dan Brown]

Bharat Bajaj wrote on Sat, 12 February 2011 21:46

Dear Friends,                     Ive a Nexo Geo S12 set up with RS18 Subs. ^a side with 2 subs each. Powered by Camco V200 for Geo S & V6 for sub bass.   The problem I face is the compression put in automatically by the NX242 controller. Though it shows a lot of head room still the system gets compressed a lot. secondly , the Amplifiers are not cliping .           Kindly suggest what i might be doing wrong. Thanks, Bharat Bajaj

Are you seeing or hearing the compression?
What is your headroom setting on the processor?

Are you amps and processor set to 26db?

Have you connected with your distributor/dealer about these problems?

sincerely,
Dan Brown

[Gareth Marsh]

Doug Fowler wrote on Tue, 15 February 2011 14:54

Polarity on the sense lines does not matter.

Apologies. Should have said correct sense wiring.

Although I would expect it to show a sense error if the wiring was that badly messed up.


Gareth

[ProSoundWeb Community]