ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: A Cheap, Useable, NCVT  (Read 485 times)

Dennis Wiggins

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 580
A Cheap, Useable, NCVT
« on: October 16, 2017, 04:34:17 pm »

After trying 3 'budget' testers over the last few years, I finally found an NCVT that could actually detect which side of a receptacle (or which wire) is the 'hot' one.   All the others could only tell you that "somewhere near" there was voltage, without any resolution.

The sensitivity is adjustable.

The under $15 Sperry Volt Sensor model VD6505 can do it!

-Dennis
« Last Edit: October 16, 2017, 04:56:56 pm by Dennis Wiggins »
Logged

shelley watreen

  • Newbie
  • *
  • Offline Offline
  • Posts: 4
Re: A Cheap, Useable, NCVT
« Reply #1 on: November 01, 2017, 02:49:50 am »

$15....
Logged

Mike Sokol

  • Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3055
  • Lead instructor for the No~Shock~Zone
    • No~Shock~Zone Electrical Safety
Re: A Cheap, Useable, NCVT
« Reply #2 on: November 01, 2017, 07:47:06 am »

$15....
shelleywa, per the rules of this forum please change your login to your actual full name. Unless you do so, your comments will be locked out and you won't be able to post. Thanks... Mike

Mike Sokol

  • Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3055
  • Lead instructor for the No~Shock~Zone
    • No~Shock~Zone Electrical Safety
Re: A Cheap, Useable, NCVT
« Reply #3 on: November 02, 2017, 08:25:08 am »

shelleywa, per the rules of this forum please change your login to your actual full name. Unless you do so, your comments will be locked out and you won't be able to post. Thanks... Mike

Thanks for updating your login name. And welcome...
Pages: [1]   Go Up
 


Page created in 0.848 seconds with 17 queries.