ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Dante Controller - IP Protocol Control Possible?  (Read 674 times)

Ian Bethell

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
  • Ian Bethell
Dante Controller - IP Protocol Control Possible?
« on: September 14, 2017, 12:11:22 pm »

Hello all, does anyone know if it is possible to change Dante routing over IP Control?

Scenario: I want to be able to switch a single Dante output between multiple inputs using a crestron type controller.
Logged

David Sturzenbecher

  • Hero Member
  • *****
  • Online Online
  • Posts: 1232
    • Sturz Audio
Re: Dante Controller - IP Protocol Control Possible?
« Reply #1 on: September 14, 2017, 01:16:24 pm »

Have you looked to see if crestron offered this feature already? During Level 2 training, I was told this was already in the works. Audinate offers their API, not sure if there is a cost though. 


Sent from my iPhone using Tapatalk Pro
Logged
CTS-D, CTS-I
AES Full Member

Mike Nicolai

  • Newbie
  • *
  • Offline Offline
  • Posts: 4
Re: Dante Controller - IP Protocol Control Possible?
« Reply #2 on: October 12, 2017, 09:56:24 am »

Which devices are you using for audio that you want to control?

What I typically do for these situations is bring all of my Dante inputs into a router block within a DSP that feeds into the outputs I want to drive. Then I'll send TCP/IP commands to the DSP to switch between each source. This is more a traffic cop approach. It does not actually tamper with any Dante routing it just redirects the signal flows.

I have not yet seen anyone issuing straight TCP/IP commands to a Dante chipset to repatch the routing. I would also tend to avoid this myself because if a power user takes it upon themselves to rename a device or channel, or a device has to be sent to the MFR under warranty and comes back with a new Dante name, new firmware, or gets replaced with another unit, all of the TCP/IP commands hard coded into the Crestron controller would fail and require a service call and freshly compiled code.
Logged
Mike Nicolai, CTS-D
Sarasota, FL

James Cotton

  • Newbie
  • *
  • Offline Offline
  • Posts: 30
Re: Dante Controller - IP Protocol Control Possible?
« Reply #3 on: November 14, 2017, 10:17:01 am »

Have you looked to see if crestron offered this feature already? During Level 2 training, I was told this was already in the works. Audinate offers their API, not sure if there is a cost though. 


Sent from my iPhone using Tapatalk Pro

The API was mentioned on the Level 3 training course last week as a licensable intellectual property so bottom lime is it's possible but it'll cost you.
Logged
Pages: [1]   Go Up
 


Page created in 0.067 seconds with 19 queries.