ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: Goes down to 2...  (Read 4739 times)

Jason Glass

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 918
    • CleanWirelessAudio.com
Re: Goes down to 2...
« Reply #10 on: September 11, 2017, 05:56:20 PM »

But what about his tone? Wasn't it awful because of the low volume??? (end sarcasm)

There's nothing better than working with a band where the guitarist and drummer both "get it" - that the amp doesn't need to be set to 11, and that the snare doesn't need to be cracked at 120dB with every hit.

It's so wonderful when the stage volume is appropriate for the venue/genre.
Indeed! In my several years touring with Tanya Tucker, the lead guitar tone delivered from Roger Eaton's 15W boutique amps was never anything short of spectacular. And he was standing 15 feet from Jack Gavin, the undisputed loudest (arguably awesomest) drummer out of Nashville. Those guys understood dynamics and sound reinforcement. And everyone in the room was in a happy place.

Sent from my Nexus 5 using Tapatalk

Stephen Kirby

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3006
Re: Goes down to 2...
« Reply #11 on: September 11, 2017, 06:24:30 PM »

The Fender Hot Rod series have cost constrained output transformers and sound terrible turned up.  Particularly the Deluxe.  The Deville get's pretty loud before this happens and when you push them too hard, they turn into this Tube Screamer kind of middiness, which some folks actually like.  At reasonable volumes they can sound great though if the musician has hands.

As for the Monster Cable?   ::)  Overpriced, microphonic junk.  Especially into a high impedance tube amp.  Slap one on a stage and it's almost as loud as the guitar.
Logged

Bob Leonard

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6807
  • Boston, MA USA
Re: Goes down to 2...
« Reply #12 on: September 12, 2017, 10:40:18 AM »

Most Fender tube amps, including the Deville, barely produce any volume at "2" and start to "grind" at about 4-5. I would imagine this player has a good clean boost between the guitar and amp pushing the pre amp, but not too hard. The result is a good full clean sound with some fullness to it.

This player is only using the clean channel of the amp, obviously cares about the levels, and has set the tone controls on the Deville where it will sound very much like a Princeton Reverb and at the same output levels. Good on him, and an example of what I preach constantly.

Exceptions may be the Princeton clones I build that can be turned up to "8" in most cases without distortion (trade secrets here). Maybe Steve Hurt will chime in about the Princeton clone I built for him.
« Last Edit: September 12, 2017, 10:43:05 AM by Bob Leonard »
Logged
BOSTON STRONG........
Proud Vietnam Veteran

I did a gig for Otis Elevator once. Like every job, it had it's ups and downs.

g'bye, Dick Rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7424
  • Duluth
Re: Goes down to 2...
« Reply #13 on: September 12, 2017, 02:05:35 PM »

Yes, Bob, he did have a "drive" pedal.  I didn't get a picture of it, just a non-discript gray box labeled over-drive IIRC.

Is this a 335?
« Last Edit: September 12, 2017, 02:09:19 PM by dick rees »
Logged
Pay no attention to the man behind the curtain...

Stephen Kirby

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3006
Re: Goes down to 2...
« Reply #14 on: September 12, 2017, 04:40:37 PM »

There are more boutique drive pedals out there than kick microphones.  And they're getting to the point where the amp doesn't need to be cooking to sound natural.
Nondescript might be a Wampler.  But everybody and their cousin are playing with part substitutions in a Tube Screamer and putting them out on the internet. 
Logged

ProSoundWeb Community

Re: Goes down to 2...
« Reply #14 on: September 12, 2017, 04:40:37 PM »


Pages: 1 [2]  All   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.036 seconds with 24 queries.