ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Installation Education  (Read 483 times)

Andy Geipel

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
Installation Education
« on: September 07, 2017, 03:11:30 pm »

AVL system designers/integrators:  where are you formally learning how to hang suspended loads?  I'm transitioning from system component spec'ing to full-installation design and want to do it the right way. 

My assumption is many smaller shops are creating (appropriate) solutions based on rated available rigging hardware.  Is that correct?  Are there best practices covered in CTS-I or D?  ETCP is out for me as I don't spend enough times hands-on in theaters.

Thanks!
Logged

Mac Kerr

  • Old enough to know better
  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5674
  • Audio Plumber
Posting Rules
« Reply #1 on: September 07, 2017, 03:43:58 pm »

AVL system designers/integrators:  where are you formally learning how to hang suspended loads?

Please go to your profile and change the "Name" field to your real first and last name as required by the posting rules displayed in the header at the top of the section, and in the Site Rules and Suggestions in the Forum Announcements section, and on the registration page when you registered.

Mac
Logged

Andy Geipel

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
Re: Posting Rules
« Reply #2 on: September 08, 2017, 02:20:35 pm »

Please go to your profile and change the "Name" field to your real first and last name as required by the posting rules displayed in the header at the top of the section, and in the Site Rules and Suggestions in the Forum Announcements section, and on the registration page when you registered.

Mac

Updated; thank you for helping me out.
Logged
Pages: [1]   Go Up
 


Page created in 0.064 seconds with 19 queries.