ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Lab horns and USB crossover advice  (Read 251 times)

Kieran frediani

  • Newbie
  • *
  • Offline Offline
  • Posts: 3
Lab horns and USB crossover advice
« on: March 26, 2017, 09:11:17 am »

Right I've just prurchased 5 lab horns(eminiamce lab loaded), 2 USBs with celestion Ftr's, and a turbo tms4. I've got a couple questions. Basically at the moment I want to use 4 labs one USB and get some different tops to go on top (recommendations would be handy), so am I right thinkikg that I should cross the labs from 30-80 and the USBs 80-180) or the drop from the tops. I'm also not sure how the impudence would work, they are 6oms drivers wired in parallel so that's 3ohms a cab and could wire them in series parallel to an amp to get a 3ohms load 2 cabs a channel. Is that correct? And will most amps run 3ohms? Should probably add that I'm probably going to get 8 or 12 labs in total to sit under the 2 USBs, what would be good for the top end?
Thanks
Logged

Will Knight

  • Full Member
  • ***
  • Offline Offline
  • Posts: 126
Re: Lab horns and USB crossover advice
« Reply #1 on: March 26, 2017, 11:19:30 am »

Please go to your profile and change your user name to your real name as required and posted in the rules for the PSW forum when you initialled registered.  Otherwise, your post will be locked by the Moderator
Logged
Pages: [1]   Go Up
 


Page created in 0.089 seconds with 17 queries.