I've had it working on a QL but had to call both Shure then Yamaha tech support to get it working
- Dante must be using autoconfig IP address for all devices
- There are some menu setting for the ULX-D regarding network that must be right. I don't recall the names or setting but they were pretty self explanatory and also in the manual.
- console control network settings don't matter
- to get it working I had to do a factory reset on the QL by holding a couple of buttons at startup (resets all scene data FYI)
Hope this helps
I found some Shure settings highlighted in this video link: https://www.youtube.com/watch?v=6Cj2jhbkPSE
I'm trying this, and I've gotten to the point where I can see the mics in the console's Dante module loader settings. 2 ULXDQ's "connect" temporarily, occasionally hold for a while, then disconnect. They do, however, consistently appear in the Dante device mounting menu. When I tap on the units in the Dante I/O devices menu, it tells me that the "feature isn't available right now", and the little widget icon sometimes appears as "unsupported". Also using a Rio3224 which consistently works jes' fine!
I've updated the firmware on the receivers, and have come down to the thought that I may need to update the firmware on the console/Dante card in addition to using a better switch! Mine is rather old.
Any thoughts on whether or not using cat5e vs. cat6 matters other than speed or interference?