Hi All,
(mods: not sure if this fits best here or in the general audio forum, I'll let you decide!)
So an interesting day for me today. I'm at a big TV awards show here in the UK. All the big names playing, suitably challenging RF environment, but with equally capable technicians on the scene. I'm with a couple of the acts, but one in particular throws up an interesting issue.
He's complaining of odd distortion in his IEM mix. He's right down the end of a long thrust from the main stage, on a little 'B stage'. I head out there to have a listen to his pack, and its basically clean. And then he plays his guitar, and its like everything everywhere is clipping. Hideous noises, that aren't coming down any audio inputs.
So I summon my friendly RF tech, who appears with his R&S FSH3 to have a look. There is loads and loads of LED on this show, so everyone is a little nervous about the RF environment.
Long story short, the interference is being generated by the guitar amplifier. Here's the specifics:
- Interference appears as many brief narrow spikes accross the entire 65MHz band we're working in. Almost like lots of brief IEM carriers.
- It doesn't happen when the guitar is on and not being played, so I don't think its being induced by the guitar pickups
- certain pedal combinations make it worse, and these seem to correspond to the settings with the most gain, and therefore the most distortion at the amp
- the amp is an Orange Rockverb 50MkII 2x12 combo. It's valve driven
Very, very odd. Its like the guitar amp is producing some very out-of-band RF emissions when the tube's distort. The harder they are driven, the worse the emissions.
Anyone experienced anything like this before? Thoughts?
He uses this setup often with no issues, but this particular amp is a rental for a one-off show, so I would suggest that this issue is specific to this individual amp, rather than all such amps.