I dont know if this is useful to anyone but....
I have all my ulx-d receivers connected to a dante network, and wanted to use dante controller, wwb and the console editor at the same time.
Dante uses the auto ip in the 169.254.x.x range
The console defaults to 192.168.1.x range
And I discovered the receivers have a dante ip address, but also a *control* ip address, which defaults to 192.168.2.x range.
Having had all kinds of issues with wwb using the a 169.254.x.x address on my laptop ( units disappearing, unable to perform scans etc.) I set my pc to have 3 ip addresses, one in each of the ranges I mentioned above, and set wwb to use thie 192.168.2.x address (appears as a separate network interface in wwb settings.
It worked a treat and I was able to use wwb, Dante controller and console editor no problem.
In order to add extra ip addresses in windows you need to go to the ipv4 settings and click on advanced, then click add. I had no idea you could do this until we googled it during a very long boring show.....