ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Calibrate DiGiCo SD10 Screen  (Read 13139 times)

Chris Trupe

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 61
Calibrate DiGiCo SD10 Screen
« on: June 30, 2014, 04:32:48 PM »

It appears the calibration on the screen is off, if wherever I touch it responds as I am touching about an inch or two higher.  Anyone know the procedure to re-calibrate the touch screen?
Logged

Brian Bolly

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 672
  • DC/Baltimore and other Major Airports
Re: Calibrate DiGiCo SD10 Screen
« Reply #1 on: July 05, 2014, 02:50:56 PM »

It appears the calibration on the screen is off, if wherever I touch it responds as I am touching about an inch or two higher.  Anyone know the procedure to re-calibrate the touch screen?

It's been a while, but I believe you have to quit to Windows (Alt + F4) and there is a "Test" application - check the Start menu.
Logged

Christian Güssmer

  • Newbie
  • *
  • Offline Offline
  • Posts: 47
    • www.guessmer.de
Re: Calibrate DiGiCo SD10 Screen
« Reply #2 on: July 11, 2014, 09:50:18 AM »

from what I was told:

1st check that the screen edges are clean, if there is dust or something similar it might confuse the touchscreen

to re-calibrate quit to windows (alt+F4), right click on "start" and choose "explore". On harddisk D: in the SD8 directory run SD?test.exe (where ? is probably 10 in your case)
Logged

ProSoundWeb Community

Re: Calibrate DiGiCo SD10 Screen
« Reply #2 on: July 11, 2014, 09:50:18 AM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.031 seconds with 23 queries.