ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: replacing 725 crossover  (Read 1280 times)

Bob Kidd

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 647
replacing 725 crossover
« on: April 30, 2014, 11:35:23 PM »

I have to replace internal crossover in srx 725 and ordered part. Has anyone done this before? If so is it easy to replace? Would rather save a little on having someone else do it. Thanks
Logged

Thomas Le

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1139
Re: replacing 725 crossover
« Reply #1 on: April 30, 2014, 11:50:00 PM »

I wouldn't think it would be that hard, just take the wires out of the old one and put in the new one, but make sure to note which wire goes to what driver beforehand. Also make sure it's the exact same crossover, kinda obvious but just to be sure.


Sent from my iPhone using Tapatalk
Logged

Bob Kidd

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 647
Re: replacing 725 crossover
« Reply #2 on: May 01, 2014, 12:02:18 AM »

I wouldn't think it would be that hard, just take the wires out of the old one and put in the new one, but make sure to note which wire goes to what driver beforehand. Also make sure it's the exact same crossover, kinda obvious but just to be sure.

Thanks, no soldering involed?

Sent from my iPhone using Tapatalk
Logged

Thomas Le

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1139
Re: replacing 725 crossover
« Reply #3 on: May 01, 2014, 12:11:09 AM »

Nope, you unplug the connectors from the crossover to the drivers and also the input panel. No soldering needed.


Sent from my iPhone using Tapatalk
Logged

ProSoundWeb Community

Re: replacing 725 crossover
« Reply #3 on: May 01, 2014, 12:11:09 AM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.034 seconds with 26 queries.