Hello all,
Need a little bit of help is anyone can help or guide me in the correct direction, basically, I am changing the settings of my soundsystem and also getting more equipment for the system,
Im wondering is it possible to use a DCX2496 to set gains & limit amplifiers to a curtain output (Power Watts) which will then allow me to just use the dcx as the control of amplifiers instead of adjusting the amplifers dials, hopefully that makes sense,
I have a AVC 2 which will be the system limiter which will go inbetween the mixing desk and the DCX 2496,
heres the amplifers, their specs and what i need from each amplifer in relation to power for the drivers RMS
Processor is a DCX 2496
amplifiers are
x4 pxm 1450........... 2400w pc @ 4 ohm
x2 cmark mr3000.... 1600w pc @ 4 ohm
x1 t.amp 2400........ 1200w pc @ 4 ohms
x1 t.amp 2400........ 650w pc @ 8 ohms
x1 qsc rmx 850....... 280w pc @ 4 ohms
x1 qsc rmx 850....... 180w pc @ 8 ohms
what the settings need to be at,
x4 pxm 1450........... 2000w pc @ 4 ohm..... input sensitivity 0.775v
x2 cmark mr3000.... 1400w pc @ 4 ohm..... input sensitivity 0.775v
x1 t.amp 2400........ 1000w pc @ 4 ohms..... input sensitivity 0.775v
x1 t.amp 2400........ 500w pc @ 8 ohms..... input sensitivity 0.775v
x1 qsc rmx 850....... 200w pc @ 4 ohms......input sensitivity 1.15v
x1 qsc rmx 850....... 100w pc @ 8 ohms......input sensitivity 1.15v
trying to work out both the output gain and the limit level for the dcx
Thanks in advance
Shaun