ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: SD7 offline editor - output HPF/LPF access  (Read 1813 times)

peter dakin

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
SD7 offline editor - output HPF/LPF access
« on: May 01, 2014, 06:45:01 AM »

Is there a way to access the HPF/LPF section on outputs?
The SD7 editor has two tabs, covering where you'd normally find these options.
The tabs are "pre-insert eq" or "post-insert eq".

Can't seem to find anything relating in the options page. Its not a big deal as only take 2sec's to enter them in on the desk, just odd that in previous editors I've used the HPF/LPF sections have been easily availble.

They're present in their usual position on inputs, its just the output sections that have this different tab (AUX, GROUP, MATRIX).

If in a SD9 editor (where normal buttons are) I save an aux HPF/LPF eq setting to a preset. Then import preset into SD7, the SD9 EQ isn't there.
Logged

Chip Sciacca

  • Newbie
  • *
  • Offline Offline
  • Posts: 49
Re: SD7 offline editor - output HPF/LPF access
« Reply #1 on: May 01, 2014, 10:48:53 AM »

I'm pretty sure what Digico did  was eliminate those filters to give you 8 bands of paraEQ on your outputs. thats why you have a 4 band pre, and 4 band post EQ now.
Logged
Tech Support Engineer
Group One Ltd.
DiGiCo USA
Klang USA

peter dakin

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
Re: SD7 offline editor - output HPF/LPF access
« Reply #2 on: May 01, 2014, 12:36:07 PM »

I'm pretty sure what Digico did  was eliminate those filters to give you 8 bands of paraEQ on your outputs. thats why you have a 4 band pre, and 4 band post EQ now.

You're right!
After a further play, you only get shelf options on the post-insert bands, so if you were wanting to mould an IEM broadcast EQ, you have to use the post shelves to create your hi-pass/lo-pass.

I welcome the extra paraEQ, but would have liked to have seen the HPF/LPF option in there as a 3rd option with the Shelf/Bell button.
Logged

Chip Sciacca

  • Newbie
  • *
  • Offline Offline
  • Posts: 49
Re: SD7 offline editor - output HPF/LPF access
« Reply #3 on: May 01, 2014, 03:47:13 PM »

they actually did that at the request of a bunch of engineers now not needing to carry around a lake.
Logged
Tech Support Engineer
Group One Ltd.
DiGiCo USA
Klang USA

ProSoundWeb Community

Re: SD7 offline editor - output HPF/LPF access
« Reply #3 on: May 01, 2014, 03:47:13 PM »


Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.033 seconds with 25 queries.