ProSoundWeb Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: Is it worth it  (Read 6817 times)

Steve M Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3381
  • Isle of Wight - England
Re: Is it worth it
« Reply #10 on: December 17, 2013, 02:48:25 AM »

Have you tried discussing it with the band?  I know it's usually a delicate matter

It's not a delicate matter if you're considering not working with them again.


Steve.
Logged

Cosmo

  • SR Forums
  • Full Member
  • *
  • Offline Offline
  • Posts: 186
  • Northern Colorado, USA
Re: Is it worth it
« Reply #11 on: December 17, 2013, 11:45:50 AM »


Buy some plexi, make some shields, tell them you want to isolate their instruments just a bit...

I'm sure Bob meant to say Lexan (do NOT use Plexiglas).  All you need to start with is one piece, 1/4 inch thick, as wide as the drum kit and about 18 inches tall.  Make two stands (or adapt mic stands) and place it at the appropriate height in front of the kit.  As was also mentioned, put some absorption behind the drummer.  Two rectangles of pegboard, about 3 ft. by 4 ft., covered with carpet and leaned against the back wall, would work fine.  And the Lexan and carpeted pieces will take up very little room in the van.

Logged
If a man does not keep pace with his companions, perhaps it is because he hears a different drummer.  Let him step to the music he hears, however measured or far away.  - H.D. Thoreau

sam saponaro

  • Full Member
  • ***
  • Offline Offline
  • Posts: 190
Re: Is it worth it
« Reply #12 on: December 17, 2013, 08:39:25 PM »

Just talk to them tell them the problem you are having and offer a drum shield as a solution.If they truely care about there sound and not there egos they will cooperate.
Tell the singer to please keep his feet off the equipment.Or if you have another set of small main pa speakers take away the wedges and put up side fills he can't trample on.If hes abusing mics tell him flat out to cut it out.
If the singer can't understand your gear cost you money and he should respect your property he don't sound like a guy i'd want to work with anyways.
Logged

Bob Leonard

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6807
  • Boston, MA USA
Re: Is it worth it
« Reply #13 on: December 20, 2013, 06:36:42 PM »

I'm sure Bob meant to say Lexan (do NOT use Plexiglas).  All you need to start with is one piece, 1/4 inch thick, as wide as the drum kit and about 18 inches tall.  Make two stands (or adapt mic stands) and place it at the appropriate height in front of the kit.  As was also mentioned, put some absorption behind the drummer.  Two rectangles of pegboard, about 3 ft. by 4 ft., covered with carpet and leaned against the back wall, would work fine.  And the Lexan and carpeted pieces will take up very little room in the van.

Yes, Lexan is what I meant.
Logged
BOSTON STRONG........
Proud Vietnam Veteran

I did a gig for Otis Elevator once. Like every job, it had it's ups and downs.

Dennis Wiggins

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 857
Re: Is it worth it
« Reply #14 on: December 21, 2013, 06:01:54 PM »

...be careful what you recommend!
.
.
.
« Last Edit: December 21, 2013, 06:04:24 PM by Dennis Wiggins »
Logged

Dennis Wiggins

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 857
Re: Is it worth it
« Reply #15 on: December 21, 2013, 06:02:59 PM »

Plexi, that is.

[/quote]
Logged

sam saponaro

  • Full Member
  • ***
  • Offline Offline
  • Posts: 190
Re: Is it worth it
« Reply #16 on: December 23, 2013, 04:43:36 PM »

So......what happened? Did you end up keeping them on as clients?
Logged

ProSoundWeb Community

Re: Is it worth it
« Reply #16 on: December 23, 2013, 04:43:36 PM »


Pages: 1 [2]  All   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.041 seconds with 24 queries.