Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Mark Campbell]

Just unboxed a Soundcraft Expression 3. Reflashed to the latest firmware. Immediately see that the faders need calibrated but can't find any mention of it in the manual. Anyone with experience on how to?

[Bob Leonard]

That would be a new one on me. You're the first person I have heard of with this problem. What makes you think they need calibration?

[Samuel Rees]

I don't know of a way. Call Soundcraft, they are pretty responsive.

[Mark Campbell]

That would be a new one on me. You're the first person I have heard of with this problem. What makes you think they need calibration?

At dead bottom, faders are not always aligned to each other. Not off by much, but off.

[Jamie Chappa]

At dead bottom, faders are not always aligned to each other. Not off by much, but off.

I have the same thing on mine, post your findings please.

[Mark Campbell]

I have the same thing on mine, post your findings please.

Reply from Soundcraft is that there is not calibration procedure.

[Michael Grimaila]

Reply from Soundcraft is that there is not calibration procedure.

Are the recalled faders that are not at the absolute bottom travel fully attenuated?

In other words, if you set a fader at minimum and then switch to a different mix, then return to the original mix is the signal at minimum (e.g., the fader is not physically at minimum but is logically at minimum)?  This would be hard to determine without some test equipment if it is only off by a little bit.

[ProSoundWeb Community]