Just drag those channels to the upper half of the screen and drop them over there. They will turn red and disappear.
My other boards (which shall remain nameless) can send and receive individual channels via firewire to a computer. I can assign one to a channel in my DAW and use any plug-in available. It's like a digital insert for lack of a better term. I know the QU-16 sends via USB during multi-track recording but does anyone know if I could do the same thing with the QU-16's USB Port? I can select USB as the input for any channel but does the mixer continually send all channels out?
Allen & Heath has the QU-Pad App on the Apple Website. I can see it with my computer but I can't see it with my iPad (in the App Store). https://itunes.apple.com/us/app/qu-pad/id699450314I got it but I had to navigate to this link with my iPad and click on the Free Button to install it.You'll need the new firmware to use it. It is also available on the QU-16 Websitehttp://www.allen-heath.com/uk/Products/Pages/ProductDetails.aspx?CatId=Qu16&ProductId=Qu16I installed the firmware update on the mixer and the QU-Pad app on my iPad. I plugged in my Apple Airport Express Router and it all seems to be working fine!
Hi MartyJust wondering if you are using the qu-pad app over a network that does NOT have an internet connection. I've been trying to get this working with both the new and old airport express units as well as an airport extreme and they all work fine until i disconnect the network from the internet. Seems weird that it needs an internet connection to work!? I'm sure I'm doing something blindingly obviously wrong but I need to use the qu-16 and au-pad at gigs _without_ an internet connection!ThanksDon
I Don't have my router attached to the internet. I do mostly outdoor festivals. No internet out there. Run the Airport Utility Click on your Router and Select EditClick near the top and select NetworkUnder Router Mode Select DHCP and NATNear the bottom Click the Network Options ButtonCheck the "Enable Nat Port Mapping Protocol" CheckboxClick Save to exit that dialog and then Click Update to send the new configuration to the Airport Express
"Cross-Fading" Between scenes.We do a lot of festivals where we have ten minutes to strike/set the stage, get the band out there and set the monitor mix. During the setup, an emcee is yammering on through the mains.While we're doing this, the channel faders must be all the way down and not muted while the emcee's channel is up. When the band is ready to go, the faders have to all be brought up at once then the emcee can be muted.Ideally, there would be a way to set the master fader all the way off and get channel faders in the ball-park. Then, when the band starts, bring the master fader up. Of course we can't do that because the emcee mic is in the mains.What would really be ideal would be to have a way to cross-fade between the emcee and the band.We're using a QU-16 so there are no subgroups or VCA's. Anyone found a creative way to deal with this problem?
Page created in 0.114 seconds with 23 queries.